Introduction; Vector2 Overview - Centurion Vector2 User Manual

Introduction

This User Guide contains all the information you need to configure and
operate your new VECTOR2 swing gate operator. From safety
instructions to basic principles of operation and an in-depth description
of your CENTURION product's many features and functions. By the time
you have finished reading this guide you will have learnt how to make
the most out of your VECTOR2. Even basic maintenance is covered but,
in the unlikely event that your CENTURION product malfunctions, rather
leave it to the professionals and contact your installer or nearest
CENTURION Branch (contact details listed on the back page) for prompt
assistance.

VECTOR2 overview

The CENTURION VECTOR2 swing gate operator is powered by a 12V DC
motor using a maintenance-free, lead acid battery as the primary power
source. The battery is charged via a 220V mains supply or a solar panel.
The major benefit of this philosophy is uninterrupted operation of the
gates even in the event of a mains power failure.
Each leaf of a single or double swing gate installation requires its own
operator.
Two models are available, the V400 and the V500, which have
actuation strokes of 400 and 500 millimetres, respectively. The operator
with the longer stroke will run the gate more slowly, however, it will be
able to handle a gate which is wider and/or heavier. Refer to the
specification table on page 32 of this User Guide for more details about
the maximum size gate and wind loading that each model of operator
can reliably handle.
Each VECTOR2 operator consists of a high-torque DC motor extending
or retracting a piston through a planetary reduction gearbox. The piston
is linked to the gate via a gate bracket and release pin. The release pins
can be fitted with padlocks where additional security is required. The
operators make use of a centrifugal braking system which prevents the
gate(s) from being forced open.
Whether a single or double swing, each system must have an electronic
controller. This is housed along with the battery supply consisting of a
maintenance-free battery (7Ah) and charger, inside a weatherproof
enclosure mounted in close proximity to the gate. The electronic
controller, which coordinates the operations of the drive units, is further
protected by a fully sealed plastic enclosure. For added reliability the
controller is fitted with lightning protection circuitry.
The VECTOR2 operator uses an innovative internal position control
system with an external fixed reference origin, to track the movement
of the gate and accurately set the 'open' and 'close' positions. As a
result of this position control system, it is not necessary to fit gate
endstops.
The operator can be fitted to either inward or outward opening swing
gates. The operator is fitted with a manual override key-release.
page 3