Autoclose Advanced Options; Pedestrian Opening - Centurion Vector2 User Manual


Features
and
functions

3.1.4. Pedestrian Opening

The Pedestrian Opening input
opens only one leaf of a double
leaf installation just wide enough
for a pedestrian to pass through
the opening. A second button on
your remote control can be used
to operate the Pedestrian Opening
function. You can also set a
keyswitch or keypad mounted
adjacent the gate entrance to
operate this function.
There is a default, but adjustable,
two second delay before the gate
opens to warn the pedestrian that
the gate is about to move as well
as give the person enough time to
move their hand away if they are
reaching through the gate to
operate a keyswitch or a keypad.
If the Courtesy Light (page 18) is
connected to the control card, it
will flash, indicating that the gate
will open a default distance of
approximately one metre
(adjustable). The gate will close
after a default time of five seconds
(adjustable).
The gate can be kept open by keeping a trigger on the input (keeping
your key in the keyswitch, for example) – once removed, the gate will
close after the default five seconds.
The Pedestrian Opening Input is fully configurable and can be set to suit
your needs. You can adjust the pre-opening time delay; the amount that
the gate opens; and the pedestrian autoclose delay using your LCD
controller. Refer to the notes on the next page.
If a Safety Beam (page 16) is fitted and the beam is broken while the
gate is closing, the gate will stop and open to the pedestrian position.
The gate will remain open while the beam is broken and the five second

3.1.3.2. Autoclose advanced options

You can also independently set Autoclose to function when the gate is
partly open, fully open or partly closed.
For example, disable Autoclose when the gate is partly closed to allow
construction workers, gardeners, etc. access to your property
(although this comes with security risks). Enabling the Autoclose in all
states of gate movement, ensures that the gate can never be left in
any position other than fully closed. The default setting when
enabling Advanced Autoclose is partly open and fully open, but not
partly closed.
page 10
FIGURE 7
FIGURE 8