Centurion Vector2 User Manual page 34

Gate does not
autoclose.
Gate starts closing
but stops and re-
opens.
Trouble-
shooting
guide
Operator drives
too far and does
not stop in the
correct open and
closed positions.
Symptom
 Infrared beam(s) (if
fitted) is(are) faulty

Check that the auto-
close override facility
is not being operated
 Intermittent operation
of infrared beam if
fitted
 Anti-crushing device
is set too sensitively
 Origin system not
functioning correctly

Origin position has
been shifted
Cause
page 30
Action
 Check that the GREEN
LEDs adjacent the 'Safe
CLS' and 'Safe OPN'
inputs are ON when the
infrared beams are clear
 Check that beam is
correctly aligned. It
should be possible to hear
the relay within the
'receiver' side of the
infrared beam 'click' as
the beam is broken and
cleared

Ensure that nobody is
mistakenly pressing and
holding down the gate-
release pushbutton on,
either the remote, or
intercom for too long
when activating the unit.
Refer section Autoclose
Override
 Check the GREEN 'Safe
CLS' LED on controller. It
must remain ON if beam
is clear
 Consult your installer if
there is a problem
 Disconnect the VECTOR2
from the gate by remov-
ing the pin from the gate
bracket. Check that the
operator runs correctly
when not loaded by the
gate. Consult your
installer if there is a
problem
 Check that the cables
from the VECTOR2
actuator are terminated
correctly and making
good contact. Consult
your installer should there
be a problem