Centurion Vector2 User Manual page 6

IMPORTANT Safety instructions
or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person
responsible for their safety.
11. Children should be supervised to ensure that they do not play
with the gate or operator.
12. Do not in any way modify the components of the automated system.
13. Do not install the equipment in an explosive atmosphere: the presence
of flammable gas or fumes is a serious source of danger and may
compromise safety.
14. Before attempting any work on the system, isolate electrical power
and disconnect the batteries.
15. The mains power supply of the automated system must be fitted with an
all-pole switch, mounted within one metre of the operator, with contact
opening distance of 3mm or greater. The use of a 5A thermal breaker
with all-pole circuit break is recommended.
16. Make sure that an earth leakage circuit breaker with a threshold of
30mA is fitted upstream of the system.
17. Never short circuit the battery and do not try to recharge the batteries
with power supply units other than that supplied with the product, or
supplied by Centurion Systems and specified for this system.
18. Make sure that the earthing system is correctly constructed, and that all
metal parts of the system are suitably earthed.
19. The installer must explain and demonstrate the manual
override operation of the gate in case of an emergency, and must
hand installation documentation, user guides and any Safety/Warning
documents provided with the operator over the end-user.
20. Explain these safety instructions to all persons authorised to use this
gate automation system, and be sure that they understand the hazards
associated with automated gates.
21. Do not leave packaging materials (plastic, polystyrene, etc.)
within reach of children as such materials are potential sources of
danger.
22. Dispose of all waste products like packaging materials, worn out
batteries, etc, according to local regulations.
23. Always check the obstruction detection system, and/or safety
devices for correct operation prior to hand over. During the hand-
over of the system, explain to the end-user how to perform these
checks to confirm that all safety devices are operating correctly.
24. Centurion Systems does not accept any liability caused by improper use
of the product, installation that does not conform to instructions as
detailed in the installation documentation, or for any use of the operator
other than that for which it was designed for.
25. This product was designed and built strictly for the use indicated in the
documentation provided with the product. Any other use, not expressly
indicated within the documentation, could be a source of danger and/or
compromise the service life/operation of the product and invalidate the
warranty.
26. Anything not expressly specified in these instructions is not permitted.
page 2