Pirac Override; Holiday Lockout Mode - Centurion Vector2 User Manual

 3.1.6.1 PIRAC Override
PIRAC (Beam Autoclose) Mode can be overridden in Standard and
Reversing Modes. Similar to overriding the Autoclose function you
must press and hold the button of the remote control or intercom
gate release for at least six seconds. The gate response will be to
start opening and then to stop for a pause time of three seconds
and then continue to open as soon as the PIRAC Override feature is
activated. Once the gate resumes opening you may release the
remote control button or intercom gate release and the gate will
continue to the fully open position with PIRAC Mode overridden.
Your gate will stay open until you use the remote control or
intercom gate release to close the gate. The VECTOR2 will then
revert to normal PIRAC operation.

3.1.7. Holiday Lockout Mode

This feature completely immobilises the operator and deactivates all
inputs so nobody can get into your property while you are away.
One of the buttons on your remote control can be used to switch the
Holiday Lockout Mode as well as a latching keyswitch or keypad
mounted adjacent the gate entrance, accessible from the outside of the
property.
When Holiday Lockout Mode is
enabled, any of the access
control devices that are
connected to the VECTOR2, will
be inactive and not even
tampering with the keyswitch,
keypad or access tag readers on
the outside of the property, will
open the gate – particularly
useful if you intend leaving your
property unattended for extended
periods of time.
If Holiday Lockout Mode is
enabled while the gate is moving
or in the open position, it will
only activate when the gate is
back in the closed position.
If somebody tries to open the gate via a valid access control
device, such as a remote control, etc. with Holiday Lockout
Mode enabled, the onboard buzzer will beep periodically for 30
seconds to confirm that the gate operation has been disabled
using this feature
Gate electronically locked
page 13
Features
functions
FIGURE 14
and