Courtesy (Pillar) Light Control; Pre-Open And Pre-Close Delays - Centurion Vector2 User Manual


Features
and
functions



3.7.1. Courtesy (Pillar) Light Control

The Courtesy (Pillar) Lights can be switched on from inside your home
or office by connecting a pushbutton to the VECTOR2 controller.
For your safety this pushbutton switches only low-voltage signals.
Press and release the button for the lights to switch on for the defined
period then switch off automatically. Press and hold the button for
three to four seconds for the lights to stay on permanently, until you
push the button again. If the Gate Status Indicator is fitted to the
intercom handset, the LED will flash once every two seconds to
indicate that the lights are on permanently.
This feature can also be operated using your remote control. Simply
set one of the spare buttons on the transmitter to switch your
Courtesy (Pillar) Lights on and off.
Please refer to Onboard Multichannel Receiver (page 22) for more
information on the various functions you can operate with your
remote control.
Low-wattage, 12V DC light fittings are also readily available and can
be connected to the system, drawing power directly from the battery.
However, please ensure that the power drawn by the lights and motor
does not exceed the recharge rate of the battery. Larger charger units
can be fitted to cope with the additional load – contact your gate
automation specialist or CENTURION for more info.
3.7.2. Courtesy (Pillar) Lights act as Warning
Light
For additional safety, the
Courtesy (Pillar) Light output
can be configured to act as a
warning light before the gate
operates and while the gate
is moving.
Contact your gate
automation specialist or
CENTURION for more details
on the different Warning
Light Modes.

3.7.3. Pre-open and pre-close delays

If you make use of the Warning Light feature, you can set your gate
to have a slight delay before it opens or closes to allow the light to
warn pedestrians or vehicles that the gate is about to move.
The pre-open and pre-close delays can be independently set and
also independent of enabling the warning light feature referred to
above.
page 20
FIGURE 24