Electrical Set-Up; Connect All Wiring; Get Into Programming Mode; Set The Gate Limits (Automatic Set-Up Routine) - Centurion D3 Installation Manual

Electrical Set-up

Electrical Set-up
WARNING

Connect all wiring

1. Connect all cables as required to the control card and battery charger, according to the wiring
diagrams on page 40 - 43.

Get into Programming Mode

2. Remove ALL power from the controller, i.e.
charger plug and battery Figure 23.
3. Fit the SET link to the SET pins as shown in Figure 24.
4. Reapply power by connecting the charger plug, and then the battery to the controller.
Immediately after reconnecting the power, the STATUS light will flash 5 times. The SET and L2
lights will be on, L1 must be off to indicate you are now in programming mode. See Figure 23
and 24. ( See Setup troubleshooting Guide, page 33, step 4)
Set the Gate Limits
5. Disengage the gearbox by manually rotating
the manual release thumbwheel fully
clockwise, or until clutch is fully disengaged
and gate can be moved by hand. See Figure
21.
6. Slide gate approximately half way open. See
Figure 22.
7. Re-engage gearbox by turning thumbwheel
anti-clockwise and moving gate until an
audible click is heard.
8. To set the gate limits
button while monitoring LED L1 (see Figure
23).
9. When L1 flashes once,
pushbutton. L2 will go out, L1 will continue to
flash once per second. (The controller is now
ready to set the gate limits).
10. To start the Automatic Set-up Routine
and hold the TEST
STATUS light comes on, then
TEST pushbutton. The Automatic Set-up
Routine commences. (
shooting Guide, page 33, step 10)
1. Always check that the mains isolator in the electrical panel is in the OFF
position, and that all high voltage circuits (more than 42.4V) are
completely isolated from the mains supply before doing any work.
2. Ensure that all low voltage systems (Less than 42.4V) are suitably
protected from damage, by disconnecting all sources of power such as
chargers and batteries before doing any work.
3. All electrical work must be carried out according to the requirements of
all applicable local electrical codes. (It is recommended that a licensed
electrical contractor perform such work.)
press and hold the TEST
release the TEST
press
pushbutton until the
release the
See Setup trouble-
WARNING
DO NOT REMOVE THE THUMBWHEEL!
Removal of the thumbwheel may result in water entering the
gearbox and void the warrantee.
Figure 21 Rotate Manual Release Thumbwheel
Page 24