Get Into Programming Mode; Set The Gate Limits - Centurion R3 Quick Setup Manual

3
G I
ET NTO
Remove all power. (IM page 28)
Fit the SET link.
Reapply power
4
S
ELECT EITHER
Press and hold the TEST button, release after 1 flash of L1.
Then again, press and hold the TEST button, and release after 1 or 2
flashes of the STATUS LED. (1 Flash=master, 2 Flashes=slave) (Installa-
tion Manual page 29)
5
S
ET THE
Press and hold TEST until the gate is closed, and then release.
NB: THE GATE MUST CLOSE. IF IT OPENS :
Release the TEST button.
Swap the respective motor wires.
Press and hold TEST until gate is closed, and then
release.
Press and hold TEST until gate is open, and then release.
Press and release TEST (When setting up the MASTER gate, it will close and
then open to pedestrian. IM page 29).
If setting up the master gate, press and release TEST once more to complete
the setup (The MASTER gate will open fully, and the SLAVE gate will move
slightly).
6
S
ETTING
Determine what features are required (See Table 2). (IM page 47)
Get into programme mode (as in Step 3), or continue from Step 5.
To select the Feature to Change: (IM page 31)
Press and hold the TEST button while monitoring L1:
Example of how to select the AUTOCLOSE feature:
The L1 light will flash once and pause,
Then flash twice and pause ...
P
ROGRAMMING
M
ASTER OR
G L
ATE IMITS
A
DDITIONAL
M
ODE
S
LAVE
F (
EATURES OPTIONAL
S
ETUP
)
11