Configuring The Lan Settings; Configuring The Ip Settings - Impediment RS-1600-X24 User Manual

RS-1600-X24 User Guide
H.2 Configuring the LAN Settings
You can configure several LAN settings for each SM using the Disk Array Administrator software:
• IP settings (see
• FTP settings (see
• Telnet settings (see
• SNMP settings (see
• Contact settings (see
• HTTP settings (see
• Security options (see
• Reset LAN Subsystem (see
H.2.1 Configuring the IP Settings
You can set three IP-related settings:
If you are not sure what IP address, subnet mask, and gateway to use, contact your LAN administrator.
Record the IP addresses, IP mask, and gateway below:
• IP address for SM module A ____________________
• IP address for SM module B ____________________
• IP mask ____________________
• Gateway ____________________
To set the IP address, subnet mask, or gateway:
1 From the System Menu, select Configuration Menu and press Enter.
The Configuration Menu displays.
2 Select LAN Configuration and press Enter.
The LAN Configuration screen displays.
3 Select IP Settings and press Enter.
The IP Settings screen displays.
214
page 214)
page 215)
page 215)
page
page
page 218)
page
• IP Address: Internet Protocol address of the SM module. Factory default is 10.0.0.1. You need
two IP addresses, one for each SM module.
• IP Mask: Subnet mask. Factory default is 255.255.255.0.
• Gateway: Optional Factory default is 0.0.0.0. See your LAN administrator for more information.
216)
217)
218)
page 219)