Configuring The Host Channels - Impediment RS-1600-X24 User Manual

G.3 Configuring the Host Channels
You can configure several settings for each host channel independently.
Table 7–1
Table 7–1 Host channel settings
Host channel Description
setting
Topology You should be sure that the topology setting is correct for your configuration. You can set the
topology to:
Link Speed You can set the speed to: 1 GB or 2 GB. When you change the link speed, the other host
channel on this I/O module changes speed to match.
Target ID FC Loop ID—You may need to change the FC Loop ID if you want the SM module to be at a
specific address or if your system checks addresses in reverse order (lowest address first).
You have two options:
CAPI LUN Each SM module has one LUN that you can change when you configure the host channels.
You only need to assign a CAPI LUN if you are using CAPI to configure the X24 Subsystem
For more
over a host channel via SCSI protocol extensions.
information about
LUNs, see <Chap If you are not using CAPI, you can set the CAPI LUN to NONE. If you are using CAPI, you
Blue 10 can set it to a value of 0-63.
pt><Emphasis>Und
You have two options for setting the LUN:
erstanding LUNs
and Viewing LUN
Information on
page 196.
lists the host channel settings and what they do.
• LOOP—Use this option for all configurations except when the SM module is connected
to a switch F-port. You must use this option if the internal hubs are enabled.
• .POINT-TO-POINT—Use this option only when you connect the SM module to a switch
F-port. If you change from Loop to Point to Point mode after already establishing a
public loop connection, the switch may ignore subsequent attempts to perform point to
point initialization. To resolve this, see
• SOFT—Use this setting if you do not care whether the SM module's Loop ID changes
when you power down and power up. This setting lets the FC loop initialization process
determine the Loop ID.
• Any number between 0 and 125—Select a specific number if you want the Loop ID to
stay the same after you power down and power up. The Disk Array Administrator
software cannot tell you which Loop IDs are available. To be sure that you have
successfully assigned the Loop ID you want, check the Loop ID after you restart the SM
module. If the SM module cannot get the specified Loop ID during the loop initialization
process, it will try to get a soft address.
• NONE—Use this setting if you are not using CAPI to configure the X24 Subsystem.
• Any number between 0 and 63—Select a specific number if you want the CAPI LUN to
stay the same when you restart (this change takes effect immediately unless the CAPI
LUN is currently in use).
7.9, "Host Fibre Channel Problems", on page 67
Configuring X24
195