Changing The Alarm Mute Setting - Impediment RS-1600-X24 User Manual

RS-1600-X24 User Guide
To configure the FC disk channels:
1 From the System Menu, select Configuration Menu and press Enter.
The Configuration Menu displays.
2 Select Channel Configuration and press Enter.
The Select Disk Channel screen displays.
3 Select the channel you want and press Enter.
4 Select the initiator ID you want and press Enter.
The system confirms that you want to make the changes.
5 Select Yes and press Enter to make the changes.
6 Press Esc to return to the Configuration Menu.
G.6 Changing the Alarm Mute Setting
You can enable or disable the audible alarm that sounds when the X24 Subsystem becomes too hot,
detects low or high voltage, or an array becomes critical or offline. Changing the mute setting lets you
turn off the alarm when it is sounding. You should turn it back on after resolving the problem.
200
– Any number between 0 and 125: Select a specific number if you want the initiator ID to stay the
same after you power down and power up. The Disk Array Administrator software cannot tell you
which IDs are available. To be sure that you have successfully assigned the ID you want, check
the ID after you restart the X24 Subsystem. If the X24 Subsystem cannot get the specified Loop
ID during the loop initialization process, it will try to get a soft address.