Accessing The Disk Array Software Using The Ethernet Port - Impediment RS-1600-X24 User Manual

• Using the serial connection to the SM and setting the address. See
Settings", on page
Once you set the IP address and subnet mask, you can use the steps in the next section to access the
Disk Array Administrator software.
B.2.2 Accessing the Disk Array Software Using the Ethernet
Port
Note You can use the RS-232 and Telnet connections at the same time. If a Telnet session is active, you can
see the activity through the RS-232 connection, and you can make changes to the configuration using
the RS-232 connection.
You can configure a variety of settings for the Ethernet connection. For more information, see
H.2, "Configuring the LAN Settings", on page
To access the Disk Array Administrator software using the Ethernet port and the Telnet utility:
1 Set up the IP address and subnet mask as described in
on page 98.
2 At the DOS or UNIX prompt, enter telnet and press Enter.
The exact steps for your Telnet program may be different. The remaining steps work for HyperTerminal
Private Edition.
3 Using the Terminal menu, select Preferences.
4 Select VT100 Arrows option, VT-100/ANSI emulation, and Terminal font. Click OK.
If you are using Windows and Telnet, you must configure the preferences and font from the Terminal
menu each time as shown below.
Click Font to set
the font as shown
here.
5 Enter the IP address or, using the Connect menu, select the X24 IP address from the menu (if present)
and press Enter.
214.
214.
H.2.1, "Configuring the IP
B.2.1, "Using the Ethernet Port for the First Time",
Accessing DAM
99