G.10Rescanning All Channels - Impediment RS-1600-X24 User Manual

RS-1600-X24 User Guide
3 Select the option you want and press Enter.
G.10 Rescanning All Channels
You can tell the X24 Subsystem to scan all disk channels for new or removed disk drives. You can use
this option when you install or remove drives. The rescan temporarily pauses all I/O processes and then
resumes normal operation.
If you are using an enclosure with an EMP, the X24 will perform a rescan automatically. With an EMP,
the EMP detects the change in drive status and updates the X24 about removed drives almost
immediately; however, installed drives will be detected after a three-minute delay. This delay is to allow
the new drives to spin up.
To rescan all channels:
1 From the System Menu, select Utilities Menu and press Enter.
The Utilities Menu displays.
206