Impediment RS-1600-X24 User Manual page 192

RS-1600-X24 User Guide
F.1.1.1 Displaying All Drives
You can display a list of all connected drives. The information includes:
• Loop ID
• Size
• Vendor
• Model number (toggles with node WWN and serial number by pressing T)
• Node WWN (toggles with model number and serial number by pressing T)
• Serial number (toggles with node WWN and model number by pressing T)
• Drive firmware revision
If any of the drives are members of an array, the following information may also display:
• Utility running: Expand, Verify, etc.
• Array number: The array's sequential position in the X24 Subsystem's array list
• Member number: The drive's sequential position in the array
Drives that are not members of any array are listed as Available. Drives that contain leftover metadata
from a previous array are listed as Leftover. This situation can arise if drives are removed and reinserted
or the drives failed temporarily and are not operating again. To clear leftover metadata, use the Clear
Metadata function. See
You can also perform two functions from the list of drives:
• View drive errors
• Blink the selected drive
174
F.1.2, "Clearing Metadata from a Drive", on page 177.