Starting The Drives; Disk Drives Leds; Power Down - Impediment RS-0800-LVD User Manual

RS--0800-LVD User Guide
If a problem is detected the ESI processor will change the color of the relevant LED to AMBER. Refer to
Chapter 4
Table 3–1
LED Indicator
System Status
Power Status
Cooling Status

3.4 Starting the Drives

All drives in the enclosure should automatically start their motors after power is applied. If this has not
occurred there may be a power problem (a power fault indication would normally be active).

3.4.1 Disk Drives LEDs

Each drive carrier incorporates two indicators, an upper (Green) and lower (Amber). In normal operation
the Green LED will be ON and will flicker as the drive operates.

3.5 Power Down

To power the enclosure down,
• Switch OFF the Power Supply modules installed in the Enclosure,
• Remove AC Mains at the power source.
32
for details of any fault indication.
ESI/Ops Panel LEDs
Symbol
either
or
Meaning
Green to signify that there is power applied to the enclosure.
Amber if the ESI processor has failed.
Green if the power supply/supplies are functioning normally,
Amber if there is a PSU failure in a dual powered enclosure.
Green if all fans are functioning correctly.
Amber if there is a fan failure in any module.