Table of Contents
Advertisement
•
Light On Sequence for Message Waiting Lamp:
This is the dialing sequence that the VPS must use to turn on a message waiting lamp at
an extension.
•
Light Off Sequence for Message Waiting Lamp:
This is the dialing sequence that the VPS must use to turn off a message waiting lamp at
an extension.
•
Call Waiting Sequence:
This sequence is carried out by the VPS to perform call waiting when the called extension
is busy. PBXs differ in how they handle this function. Test from an SLT to determine the
sequence.
•
Release Sequence for Call Waiting:
This sequence is carried out by the VPS to release call waiting. PBXs differ in how they
handle this function. Test from an SLT to determine the sequence.
Inband Signaling
These parameters are used when the Integration Mode is set to Inband. If the PBX type is set
to a KX-T series system, these parameters will be automatically set. If another type PBX is
used, check that system's installation manual for settings.
Table 3-4
Code
(default)
1
2
3
4
5
6
7
8
9
#9
Call State
Ringback Tone
The extension dialed is ringing.
Busy Tone
The extension dialed is busy.
Reorder Tone
An invalid extension number is dialed or the call is
inadvertently connected to another Voice Mail port (also
heard when no touchtone receiver is available to the Voice
Mail extension).
DND
The extension dialed has set DND feature (Do Not Disturb).
Answer
The extension dialed is answered.
Forwarded to Voice
The extension dialed is forwarded to Voice Mail and another
Mail (Ringing)
Voice Mail port is able to answer. (This lets the first Voice
Mail port, usually an Auto Attendant, send the call to the
other Voice Mail port.)
Forwarded to Voice
The extension dialed is forwarded to Voice Mail and no other
Mail (Busy)
Voice Mail ports are available to accept the call. (This
signals the Voice Mail port [usually Auto-Attendant] to let the
caller to leave a message.)
Forwarded to Extn. The extension dialed is forwarded to another non-Voice Mail
extension.
Confirmation Tone The Message Waiting Lamp On or Message Waiting Lamp
Off code is dialed successfully.
Disconnect
The caller disconnects. The central office must set a CPC
signal to the PBX line for this signal to work for outside calls.
3.2 PBX PARAMETERS AND PORT SETTINGS
Sent to the Voice Mail Port When...
Installation Manual
69
Advertisement
Table of Contents
Troubleshooting
