Panasonic KX-TVS125 Installation Manual page 123

4.4 CONNECTING THE VPS WITH THE PANASONIC KX-TD816, KX-TD1232, KX-TA1232 AND KX-TD308
Table 4-4
The PBX is not a KX-TD series or KX-TA1232
system. Since the VPS is configured to
communicate with the default PBX type at the
factory (KX-TD500 for the KX-TVS325; KX-
TD1232 for the KX-TVS125 and KX-TVS225),
this message will always appear when
connecting to another type of PBX.
The cabling between the PBX extension ports
and the VPS is not 4-wire or is improperly
connected.
The PBX is a KX-TD series or KX-TA1232 but
does not have the proper level of software
required to support DPT Integration.
The PBX is not programmed properly to support
DPT Integration.
11.
Start up completed.
a)
The Power Indicator light stops blinking when the start-up has been successful. (The
delay varies according to the system's condition.)
b)
"**ON LINE MODE**" is displayed.
c)
System prompt [>] is displayed on the screen. To enter system administration, Press
ENTER. All parameters can be set through the menu-driven program.
When the System Administrator starts operation, the system asks for the terminal
type. By choosing VT100 [2], all parameters can be set through the menu-driven
program.
Please Enter the Number:= [2]
Select [2] because Quick Setup is only available when using a personal computer
that can emulate a VT100 terminal.
Cause
Please Select Your Terminal Type.
1. ASCII TERMINAL
2. VT100
Please Enter the Number := ______
Remedy
Connect a KX-TD series or KX-
TA1232 PBX and set the PBX
type by using Quick Setup (see
Section 5 CUSTOMIZING THE
SYSTEM).
Confirm the cabling is
connected as described in
Section 2 INSTALLATION.
Contact National Parts Center
at 1-800-833-9626
or use Inband Integration under
hardware settings.
Do required integration
programming as described in
this chapter.
Installation Manual 123