Table of Contents
Advertisement
4.6 DPT INTEGRATION FEATURES AND SETUP PROCEDURES FOR THE PANASONIC KX-TDA/KX-TAW
4.6.11 Voice Mail Transfer (VTR) Button Assignment
For the Voice Mail Transfer feature to work at an extension, the extension must have the VTR
button. This button must either be a DSS/BLF or CO button with a lamp. Follow the procedure
below to assign a VTR button on an extension. (This is station level programming and should
be done at each individual phone.) PC programming is also available (see 4.6.12 Button
Assignment via PC Programming).
1.
Enter Station (Personal) Programming:
With the phone on-hook, Press the PROGRAM button.
(Display changes to PT-PGM Mode.)
2.
Press the desired Flexible (CO or DSS/BLF) button that you want to assign as the VTR
button.
3.
Press [94].
Screen output: VTR-
4.
Enter a Voice Mail floating extension number.
Screen output: VTR- _ _ _
(_ _ _ = The Voice Mail floating extension number you entered).
5.
Press STORE.
6.
Press the PROGRAM button or lift the handset to exit the Station (Personal)
Programming mode.
7.
Repeat these steps for each telephone.
Conditions:
4.6.12 Button Assignment via PC Programming
The KX-TDA/KX-TAW series users can assign buttons for Two-Way Recording (TWR), Two-
Way Transfer (TWT), and Voice Mail Transfer (VTR) via PC Programming. Follow the
procedure below to assign each button.
1.
Go to "4.Extension-1.Wired Extension-4.Flexible Key" screen.
152
Installation Manual
This button must be a flexible (CO or DSS/BLF)
button to be programmed as a VTR button. When all
Voice Mail ports are busy and this key is pressed, the
user will hear reorder tone.
Advertisement
Table of Contents
Troubleshooting
