Table of Contents
Advertisement
Table B-4
Parameter
Extension
Transfer
Sequence
Call Transfer
No Answer
Time
Notification Setting
Follow the procedure below to set the parameters for the Message Waiting Notification Device
feature. A maximum of 3 destinations (Device 1, 2, 3) can be specified per mailbox.
•
Class of Service programming determines if the subscriber is able to use this feature.
•
If the destination device is a telephone, the subscriber will be called when he has
message(s), and will have a chance to listen to the message(s).
•
If the destination device is a beeper, the subscriber will be notified when he has
message(s). If the beeper has a display, it is possible to send to it a callback number.
The caller can enter the callback number when he leaves a message. If he does not
Value Range
(Default)
Up to 12 digits
Specifies how the VPS transfers a call to an extension for
consisting of
each mailbox (Personal Transfer Sequence).
1-9, 0,
, #, Y,
D, F, R, T, S,
1-9, 0,
W, X, A
Y: System
(Y:System)
D: Disconnect
F: Flash
R: Ring
T: Tone
S: Silence
W: Transf.Wait
X: Extn
A: Answer
Notes
•
•
•
10-60s,
Specifies the length of time that the VPS must wait before
S: System
retrieving the transferred call when there is no answer at the
(System)
destination extension. This can be set for each mailbox.
Note
When "System" is selected, the VPS follows the "Call
Transfer No Answer Time" pre-assigned for the system
in the "Program - System Parameter - Others - Dialing
Parameters Menu".
B2 SYSTEM ADMINISTRATION—MAILBOXES
Description/Function
, #: DIAL CODE
When "System" is selected, the VPS follows the
"Extension Transfer Sequence" pre-assigned for
the system in the "Program - Hardware - PBX
Interface - Dialing Parameters Menu".
"System" cannot be used with other sequence
codes.
This sequence has higher priority than "Alternate
Transfer Sequence".
Installation Manual
281
Advertisement
Table of Contents
Troubleshooting
