Table of Contents
Advertisement
4.2 KX-TD500 PROGRAMMING FOR DIGITAL INTEGRATION
Table 4-2
The PBX is a KX-TD/KX-TDA/KX-TAW series or
KX-TA1232 but does not have the proper level of
software required to support DPT Integration.
The PBX is not programmed properly to support
DPT Integration.
11.
Start up completed.
a)
The Power Indicator light stops blinking when the start-up has been successful. (The
delay varies according to the system's condition.)
b)
"**ON LINE MODE**" is displayed.
c)
System prompt [>] is displayed on the screen. To enter system administration, Press
ENTER. All parameters can be set through the menu-driven program.
Please Select Your Terminal Type.
1. ASCII TERMINAL
2. VT100
Please Enter the Number := ______
12.
Go to the System Administration Top Menu. Select [5] and Press ENTER, or Type [3]
then QSET and Press ENTER for Quick Setup and follow the Auto Configuration
Instructions.
TEST: Press the INTERCOM button and then [1065]. If the VPS
answers, you have a DPT connection.
Set the DIP/Rotary Switch to position 0 after initialization is complete.
112
Installation Manual
Cause
When the System Administrator starts operation, the system asks for the
terminal type. By choosing VT100 [2], all parameters can be set through the
menu-driven program.
Please Enter the Number:= [2]
Select [2] because Quick Setup is only available when using a personal
computer that can emulate a VT100 terminal.
Remedy
Contact National Parts Center
at 1-800-833-9626
or use Inband Integration under
hardware settings.
Do required integration
programming as described in
this chapter.
Advertisement
Table of Contents
Troubleshooting
