Panasonic KX-TVS125 Installation Manual page 116

4.3 KX-TDA/KX-TAW SERIES PROGRAMMING FOR DIGITAL INTEGRATION
Note
The above screen output is an example of the KX-TDA200.
5.
Connect the jack assigned in Step 3 to the VPS.
6.
Connect your personal computer to the VPS and start your communication software (i.e.,
HyperTerminal, Procomm Plus, Smartcom...).
Communication Parameters: 9600, 8 Bit, None, 1
7.
Disconnect the power from the VPS and set the DIP/Rotary switch on the VPS to position
5.
Only perform this step when initially setting up the system.
CAUTION
Setting the DIP/Rotary switch to position 5 will default the Voice Processing
System, resulting in a loss of all user programming, and voice messages (except
User 1 and User 2 prompts).
8.
Plug in and power up the VPS and wait approximately 3.5 min while the system initializes.
"System Administration" Start-Up Sequence
Before starting the VPS, make sure all installation and line connections have
been done as described in Section 2.
116 Installation Manual
Screen output: