Table of Contents
Advertisement
B6 SYSTEM ADMINISTRATION—SYSTEM PARAMETER SETTINGS
Table B-37
Parameter
No Answer
Time for
Intercom
Paging
Announcement
Repeat Cycle
Intercom
Paging Retry
Paging Code
for Group 1-16
Paging Code
for All Groups
Other Parameters-Fax Management
You can program the VPS to automatically forward incoming fax calls to a fax extension. You
can specify a maximum of 2 fax extensions as the destination for the Automatic Fax Transfer.
If the main fax extension is not available to receive a fax, the VPS will forward the fax
transmission to the alternate fax extension.
342
Installation Manual
Value Range
(Default)
1-30 s
Specifies the length of time (in seconds) the VPS
(5)
must wait before concluding Intercom Paging when
there is no answer.
The VPS will return to the caller if the paged party
does not respond before this timer expires.
1-3 times
Specifies the number of times to announce the
(1)
intercom page.
Example:
"I have a call for (mailbox owner's name)".
1-10 times
Specifies the number of times to retry paging when
(2)
the paging destination is busy or if there is no
answer.
Note
Up to 12 digits
Specifies the intercom paging access code
consisting of
required by the PBX.
0-9, ,# for each
Note
group
(KX-TVS125/
KX-TVS225:
Group 1-8:
331-338;
All Groups
[Group 17]: 33 )
or
(KX-TVS325:
Group 1-16:
3301-3316;
All Groups
[Group 17]: 33 )
Description/Function
This setting applies only when the subscriber
has enabled "Intercom Paging" in Incomplete
Call Handling Status.
The Intercom Paging Group Number available
for each subscriber is determined on a COS-
by-COS basis.
Advertisement
Table of Contents
Troubleshooting
