Table of Contents
Advertisement
B7 SYSTEM ADMINISTRATION—HARDWARE SETTINGS
Transfer to Outside Parameters
These parameters specify how the VPS will transfer calls to outside lines from the following
services: Custom Service, Call Transfer Service, Personal Custom Service, Caller ID
Callback.
To access the menu for Transfer to Outside Parameters, follow the menu path as
shown:
System Administration Top Menu-1-6-3-4
Transfer to Outside Parameters-Outside Transfer Sequence
To access the menu for Outside Transfer Sequence, follow the menu path as shown:
System Administration Top Menu-1-6-3-4-1
Table B-50
Parameter
Call Transfer
to Outside
Sequence
Call Transfer
to Outside
Reconnect
Sequence on
Busy
354
Installation Manual
Value Range
(Default)
Up to 12 digits
Specifies the sequence the VPS uses to transfer
consisting of
calls to outside lines.
0-9,
, #, D, F, R, T,
Note
S, W, A, N
(APT/DPT
Integration: FND,
other Integration:
FTND)
Up to 12 digits
Specifies the sequence the VPS uses to reconnect
consisting of
the line when the transferred party is busy.
0-9,
, #, D, F, R, T,
S, W, A, N
(APT/DPT
Integration: F,
other Integration:
FWW)
Description/Function
The default setting (FND/FTND) includes the
sequence code "D" (Disconnect), which
executes a "blind" transfer. Removing "D" from
the sequence results in a "screened" transfer,
which is only supported with the KX-TD500
(V4M or higher). Therefore, please do not
remove "D" from the sequence unless your PBX
is the KX-TD500 (V4M or higher).
Advertisement
Table of Contents
Troubleshooting
