Table of Contents
Advertisement
B2 SYSTEM ADMINISTRATION—MAILBOXES
enter a callback number, either the System Callback No., or the caller's number if it
is received through a telephone company's Caller ID service, will be sent instead.
To access the menu for Message Waiting Notification, follow the menu path as
shown:
System Administration Top Menu-1-1-1-Mailbox No.-2-Device No. 1, 2, or 3.
Notification Setting-Device 1, 2, or 3
Table B-5
Parameter
Dial Number
Type of
Device
282
Installation Manual
Value Range
(Default)
Up to 32 digits
Assigns a telephone or beeper number to Device 1, 2, or
consisting of 1-9,
3. The subscriber can also specify the dial number from
his telephone.
0, , #
P, T, M, X
P: Pause
(None)
T: Dial Tone Detection
M: Dial Mode Switching Code (Touchtone to Pulse, or
Pulse to Touchtone)
X: Callback Number Entry Code
1-9, 0, , #: Dial Codes
Note
Notice
1. Telephone
Specifies the device to receive notification. This is
automatically set to "Beeper" when "X" is used in the Dial
2. Beeper
Number (above). The subscriber can also specify the
(Telephone)
type of device from his telephone.
Description/Function
The callback number entry code "X" must be
included in the number to be called if the Beeper
Callback No. Entry Mode is enabled through COS
and "Type of Device" is set to "Beeper". The proper
number of "Pauses" must be inserted before the
callback entry code.
When the VPS calls to a CO line via a PRI (ISDN
Primary Rate Access Interface) card of a Panasonic
PBX, please be sure to add "#" after the telephone
number (1112223333 in the example here):
Example: 9P1112223333#PP123PP456PPX#
Please contact your System Administrator for more
explanation.
Advertisement
Table of Contents
Troubleshooting
