Table of Contents
Advertisement
11
L-View for PC
7. Check Enable time display on video to turn on video time stamps or un-check it to
disable video time stamps.
8. Under Microphone, select Enabled to enable the built-in microphone on the camera
or select Disabled to disable the built-in microphone on the camera.
9. Click Update to save changes. Enter the camera admin user name (default: admin)
and password (default: left blank) and click OK. The camera will disconnect. Wait
about 15 seconds and then double-click the camera in Camera List or Auto Search to
reconnect to the camera.
11.7.3 Control Tab (Configure Status LED's and Motion Detection Sensitivity)
The Control tab allows you to configure the camera status LED's to make the camera hard-
er to spot at night. It also allows you to configure the motion detection sensitivity when us-
ing video motion detection.
To configure the camera status LED's:
1. Under Status LED Control, select one of the following:
• Normal: LED's will function as normal. For details on LED functions, see 3 Camera
Overview, page 3 or .
• Always turn off: LED's are turned off at all times.
• Turn off after connected: LED's turn on when the camera is powered on and turn
off once a network connection is made.
2. Click Update to save changes. Enter the camera admin user name (default: admin)
and password (default: left blank) and click OK. The camera will disconnect. Wait
about 15 seconds and then double-click the camera in Camera List or Auto Search to
reconnect to the camera.
To configure motion detection sensitivity:
Note
The following method works when using video motion detection. It does not work when using PIR motion
detection. For details on enabling motion detection and selecting video motion detection or PIR, see 16.4
Schedule, page 127.
1. Under Motion Detection Sensitivity, select the motion detection sensitivity between
1 (High) and 10 (Low). If Motion Detection Sensitivity is set to 1, motion detection
will be triggered if a moving object is larger than 1% of the video area. If it is set to 10,
a moving object must be larger than 10% of the video area to trigger motion detection.
2. Click Update to save changes. Enter the camera admin user name (default: admin)
and pssword (default: left blank) and click OK. The camera will disconnect. Wait
about 15 seconds and then double-click the camera in Camera List or Auto Search to
reconnect to the camera.
#LX400003; r. 2.0/14027/14265; en-US
49
Advertisement
Table of Contents
