Table of Contents
Advertisement
16
Configuring Camera Settings Using a Browser
To configure Email Alarms:
1. Under Email/FTP Trigger, select one of the following alarm triggers:
• Motion: Use Video motion detection to trigger email alarms. Video motion detection
looks for movement in the image to determine if there is motion. This means that
there may be false alarms caused by changes in lighting, trees moving in the wind,
etc.
• PIR: Use the PIR motion detector to trigger email alarms. The PIR motion detector
uses changes in temperatures (e.g. from a person moving around in front of the
camera) to determine if there is motion. PIR motion detection is less effective at
higher temperatures.
Note
•
You may also select both PIR and Motion to receive alarms from both motion triggers.
• Schedule: Send email alarms based on the settings configured under Schedule.
see 16.4.4 Scheduling (Configuring Recording and Alarm Schedules), page 130.
• Disable: Disable email alarms.
2. If you have selected Motion, under Motion Sensitivity, select the motion detection
sensitivity between 1 (High) and 10 (Low). If Motion Detection Sensitivity is set to 1,
motion detection will be triggered if a moving object is larger than 1% of the video area.
If it is set to 10, a moving object must be larger than 10% of the video area to trigger
motion detection.
Note
This setting does not affect the PIR motion detector.
3. Under Trigger Interval, enter the minimum time (in seconds) the camera will wait in
between email alarms. If this Interval is set too low, you may receive a lot of messages.
4. Under Email Recipient, enter up to 3 email addresses that will receive email alarms.
#LX400003; r. 2.0/14027/14265; en-US
128
Advertisement
Table of Contents
