Table of Contents
Advertisement
Polling Mode Options
Polling Mode Options
Definition:
These parameters only take effect for Polling Mode
RS-232 or RS-422 ports (not on the Auxiliary Port), and are completely
independent of the ACK/NAK Options <K147>.
The values of protocol characters can be changed, but the protocol events
cannot be disabled. The polling mode address is configured in the
command (see
To enable true multidrop protocol, the RS422/485 port must be enabled,
<K102,1>, in order to turn the transmitter on and off. If RS-232 is enabled
instead of RS422/485, <K102,0>, then Polling Mode will operate as a
Point-to-Point polling protocol. This is because the RS-232 transmitter is
always left on when enabled.
Serial Cmd:
<K148,RES,REQ,STX,ETX,ACK,NAK>
RES-NAK Defaults
RES: (Reset)
REQ: (Request)
STX: (Start of Text)
ETX: (End of Text)
ACK: (Acknowledge)
NAK: (Negative Acknowledge)
Note: See
Polling Mode Data Flow Examples
scenarios.
Note: See
USB HID Interface
3-8
Poll
Address).
04
05
02
03
06
15
for sample Polling Mode communication
for protocol information relating to USB.
<K140,5>
on the main
<K140>
MS-4X Imager User's Manual
Advertisement
Table of Contents
Need help?
Do you have a question about the MS-4X and is the answer not in the manual?
Questions and answers