Oce CS620 User Manual page 636

14
4
Load the desired size of paper to be adjusted on a tray, specify
Fold&Staple, then press [Start] on the control panel.
A sample pattern (No. 16) will be output.
5
Check the trimmed width (a) from the edge of the feeding sheet.
6
If the desired result cannot be obtained, touch [ADJUSTMENT] tab.
The Trimming Adjustment screen will be restored.
7
Display the required size key using up/down arrow keys, and touch it.
8
Use the touch panel keypad to enter the desired adjustment value, then
touch [<<SET].
Available range: -400 (wide) to +400 (narrow), 1 step = 0.1 mm
9
Repeat the adjustment steps from 3 to 8 until the desired result is
obtained.
10
If adjustment in any other size is required, repeat steps 3 to 9.
11
Touch [Return] to restore the Adjustment Menu screen.
Note
Enter the value so that the cover should be cut more than 2.0 mm.
If "All Size" is selected as paper size, the entered adjustment value will be
applied to all sizes. If specific paper size is selected, adjustment value will
be the sum of the entered value and the value previously specified for "All
Size".
14-76
Machine adjustment
Océ CS620/CS650 Pro