1.8.2 Installing scanner motor
When mounting scanner motor, adjust the tension
of timing belt 142 and timing belt 157 in the follow-
ing manner.
1. Loosely tighten all the screws removed in
Fig. 7-8-9 and Fig. 7-8-10. (There should be
play so that scanner motor bracket assembly
and scanner motor assembly can respectively
move right-to-left.)
Note: When mounting, do not mix the screws.
2. Hook the spring jig (belt) and secure the screws
loosely tightened in step 1.
3. Turn scanner motor pulley two to three turns to
allow the tooth sides of timing belt and gear to
be securely meshing.
4. Apply the screw lock paint to 8 screws secured.
5. Remove the spring jig (belt) used in step 3.
1600/2000/2500 ADJUSTMENT ITEMS
Scanner motor
Spring jig (belt)
Screw lock paint
1 - 76
Fig. 1-8-7
Screw
Fig. 1-8-8
December 2000 © TOSHIBA TEC
048-1
048-2