Toshiba DP1600 Service Handbook page 88

7. Apply the screw lock paint to all the screws se-
cured.
(b) Installing the wire to the pulleys
Winding the wire on pulley.
1. Fit the φ3.2 spherical terminal at the center of
the wire into the hole in the wire winding pulley.
Wind up the wires on the front and rear sides,
respectively, as shown below and secure the
wire with the clip jig to prevent it from getting
loose.
Scanner drive shaft
Hook
Wire
Ball terminal
Clip jig
Fig. 1-8-19
1600/2000/2500 ADJUSTMENT ITEMS
[Rear Side]
Hook
Wire
Spherical
terminal
Fig. 1-8-18
Clip jig
Ball terminal
065-11
1 - 80
Ball terminal
Fig. 1-8-17
[Front Side]
Hook
Scanner drive shaft
Spherical
terminal
December 2000 © TOSHIBA TEC
Pulley
065-10
065-01