User Test Mode - Toshiba DP1600 Service Handbook

1.2.3 User test mode

When you press the PROGRAM key and enter the TEST mode from the menu, the items that can be
tested by the user are displayed.
(1) AUTO TEST
This mode allows the user to independently diagnose the machine by automatically performing a
series of tests.
<Key used in operation>
PROGRAM
Select TEST MODE
SET
Select AUTO TEST
SET
Auto test run
End of TEST
Test Items
a) Flash ROM test
b) SRAM test
c) DRAM test
d) MODEM test
e) SCANNER test
f) CODEC test
g) Printer test
h) Phonebook data test Calculates and compares the check sum of the phonebook with the previ-
i) Network board test (with GF-1110)
1600/2000/2500 ADJUSTMENT ITEMS
Press the PROGRAM key
Use or keys
Use or keys
It takes about 2 minutes to
finish TEST
Calculates and compares the check sums of the firmware, function data and
language information with the previously stored corresponding check sum
values.
Same as Function Test.
Same as Function Test.
Same as Function Test.
Same as Function Test.
Same as Function Test.
Checks each part of the printer (fan, HVPS, polygon, heater, LSU) and prints
one page of test pattern (not performed when there is no paper).
ously stored check sum value.
1 - 18
<Display messages>
PROGRAM
01.DEFAURT SETTINGS
02.LISTS
03.INITIAL SETUP
TEST MODE
01.AUTO TEST
02.INDIVIDUAL TEST
03.TEST RESULT LIST
AUTO TEST
-------------------
AUTO TEST
Completed
December 2000 © TOSHIBA TEC