Networking And Remote Control - Orban OPTIMOD-FM 5500 Operation Manual

OPTIMOD-FM DIGITAL

Stereo: Determines the operating mode of the audio processing (S
F - , M
ROM LEFT

Mono from Left, Mono from Right, or Mono from Sum: switches the 5500's
stereo encoder off, using the Left, Right, or Sum (L+R) respectively as the pro-
gram source. This also determines the feed to the entire processing chain so that
facilities that do not use the 5500's stereo encoder can change stereo/mono
mode and select the source when in mono mode.

Mod Reduction 1, or Mod Reduction 2: reduces the program modulation by
the percentage programmed in S
on page 2-21). When voltage is removed, these functions are deactivated.

Reset Clock To Hour: resets the internal clock to the nearest hour. For exam-
ple, 3:03:10 would be reset to 3:00:00, while 3:53:40 would be reset to 4:00:00.
Use this function to periodically re-sync the 5500's internal clock to your station's
master clock.

Reset Clock to Midnight: Resets the clock to 0:00:00. You can use this function
to periodically re-sync the 5500's internal clock to your station's master clock.

No Function: remote input is disabled.
3. End remote control interface programming.
When you are finished programming the remote control interface, press the Es-
cape button to return to higher menu levels.

Networking and Remote Control

[Skip this step if you do not wish to connect to your 5500 remotely, either for
downloading software upgrades or for PC Remote Control.]
The 5500 has a built-in Ethernet connector that can be used with 10 Mbps or 100
Mbps ports using the TCP/IP protocol. You can also connect a PC to the 5500 through
the 5500's RS-232 serial port, either by modem or directly through a null modem ca-
ble.
1. Prepare the 5500 for an Ethernet network connection:
[Skip this step if you will not be using an Ethernet connection.]

See your network administrator to get the data required in the following
procedure.

Note that if you wish to do this from the 5500 PC Remote software, then you
must first be able to connect to the 5500. Therefore, you will usually perform
this procedure from the 5500's front panel to prepare it for connection.
, or M
-F -R
ONO ROM IGHT
ETUP
.)
-F -S
ONO ROM UM
> N > M
EXT ODULATION
INSTALLATION
, M
TEREO ONO
R (see step 21
EDUCTION
2-43
-