Orban OPTIMOD-FM 5500 Operation Manual page 118

2-70
INSTALLATION
Not all PCs have a COM2.
IMPORTANT: The COM port you choose at this point must match the
COM port to which you connected your modem.
g) From the tabs at the top, choose "Port Settings" and configure the settings
to match your PC modem.
If you are using a U.S. Robotics® external modem, the settings will be:
Bits per second= 115200, Data bits = 8, Parity = None, Stop bits = 1, Flow
Control = None.
h) When you are finished, click the OK button to close the "Communications
Port (Comx) Properties" dialog box.
i) Click the OK button in the "Systems Properties" dialog window.
j) Close the "Control Panel" window.
If your modem is already installed, skip to Launch an existing Windows XP modem
connection on page 2-74.
B) Install the Windows XP modem:
a) Use either an internal modem or external modem with your computer.
If you are using an external modem, connect the modem to a serial port
on your PC and make sure the modem is connected to a working phone
line.
b) On your PC, click "Start > Settings > Control Panel > Phone and Modem
Options."
c) Click the "Modems" tab.
d) Verify that your modem appears in the list available under "The following
Modems are installed."
e) Verify that your modem is "Attached to" the correct port.
If your modem is unavailable or not attached to the correct port, you will
need to Add it. See your Windows documentation.
f) If your modem is available in the list available under "The following
Modems are installed" and it is attached to the correct port, then click
"Properties" for that modem.
g) Make sure the port speed is set at 115200.
h) Click "OK."
ORBAN MODEL 5500