Networking And Remote Control - Orban OPTIMOD 6300 Operating Manual

Digital multipurpose audio processor, version 1.1 software
Hide thumbs Also See for OPTIMOD 6300:
Table of Contents

Advertisement

2-36
INSTALLATION

Networking and Remote Control

Reset Clock To Hour: resets the internal clock to the nearest hour. For
example, 3:03:10 would be reset to 3:00:00, while 3:53:40 would be reset
to 4:00:00. Use this function to periodically re-sync the 6300's internal
clock to your station's master clock.
Reset Clock to Midnight: Resets the clock to 0:00:00. You can use this
function to periodically re-sync the 6300's internal clock to your station's
master clock.
Mute Analog Output: When voltage is applied, the analog output
mutes. One could use this as an "off-the-air alert" by driving this output
with an external loss-of-carrier or loss-of-audio alarm system to mute the
talent headphones or monitor speakers.
Mute Digital Out 1: When voltage is applied, digital output #1 mutes.
Mute Digital Out 2: When voltage is applied, digital output #2 mutes.
No Function: remote input is disabled.
3. End remote control interface programming.
When you are finished programming the remote control interface, press the Es-
cape button to return to higher menu levels.
[Skip this step if you do not wish to connect to your 6300 remotely, either for
downloading software upgrades or for PC Remote Control.]
The 6300 has a built-in Ethernet connector that can be used with 10 Mbps or 100
Mbps networks using the TCP/IP protocol. You can also connect a PC to the 6300
through the 6300's RS-232 serial port, either by modem or directly through a null
modem cable.
1. Prepare the 6300 for an Ethernet network connection:
[Skip this step if you will not be using an Ethernet connection.]
 See your network administrator to get the data required in the following pro-
cedure.
 Note that if you wish to do this from the 6300 PC Remote software, then you
must first be able to connect to the 6300. Therefore, you will usually perform
this procedure from the 6300's front panel to prepare it for connection.
A) Navigate to S
ETUP
B) Press the S
IP A
ET
The IP Address Screen appears.
> N
& R
ETWORK
EMOTE
soft button.
DDRESS
ORBAN MODEL 6300
.
> N
EXT

Advertisement

Table of Contents
loading

Table of Contents