2-2
INSTALLATION
TYPE 18/3 SVT COR, TYP
(3 x .82 mm
2
)
PLUG FOR
115 VAC
(USA)
TYPE H05VV - F - 0.75
PLUG FOR
230 VAC
(EUROPEAN)
2. Install the appropriate power cord.
AC power passes through an IEC-standard mains connector and an RF fil-
ter designed to meet the standards of all international safety authorities.
The power cord is terminated in a "U-ground" plug (USA standard), or
CEE7 / 7 plug (Continental Europe), as appropriate to your 5500's Model
Number. The green/yellow wire is connected directly to the 5500 chassis.
If you need to change the plug to meet your country's standard and you
are qualified to do so, see Figure 2-1. Otherwise, purchase a new mains
cord with the correct line plug attached.
3. Mount the 5500 in a rack.
The 5500 requires one standard rack unit (1 ¾ inches / 6.4 cm).
There should be a good ground connection between the rack and the 5500 chas-
sis — check this with an ohmmeter to verify that the resistance is less than 0.5.
Mounting the unit over large heat-producing devices (such as a vacuum-tube
power amplifier) may shorten component life and is not recommended. Ambient
temperature should not exceed 45C (113F) when equipment is powered.
Equipment life will be extended if the unit is mounted away from sources of vi-
bration, such as large blowers and is operated as cool as possible.
4. Connect inputs and outputs.
See the hookup and grounding information on the following pages.
WIRE COLOR
CONDUCTOR
NORMAL
L
LINE
BROWN
NEUTRAL
N
BLUE
E
EARTH GND
GREEN-YELLOW
CONDUCTOR
WIRE COLOR
L
LINE
N
NEUTRAL
E
EARTH GND
GREEN-YELLOW
Figure 2-1: AC Line Cord Wire Standard
ORBAN MODEL 5500
ALT
BLACK
WHITE
GREEN
BROWN
BLUE