To Create Or Save A User Preset - Orban OPTIMOD-FM 5500 Operation Manual

3-14
OPERATION

To Create or Save a User Preset

Further, be aware of the different peak factors on voice and music — if voice and
music are peaked identically on a VU meter, voice may cause up to 10 dB more peak
gain reduction than does music! (A PPM will indicate relative peak levels much more
accurately.)
The AGC meter can be switched (within the Full Control screens) so that it either
reads the gain reduction of the Master (above-200 Hz) band, or the difference be-
tween the gain reduction in the Master and Bass bands.
The latter reading is useful for assessing the dynamic bass equalization
that the AGC produces and it helps you set the AGC BASS COUPLING
control.
Once you have edited a preset, you can save it as a user preset. The 5500 can
store an indefinite number of user presets, limited only by available memory.
The 5500 will offer to save any edited, unsaved preset when the main screen is
visible. To save a preset:
A) Press the ESC button repeatedly until you see the main screen, which shows
the current time and the preset presently on air.
If there is an unsaved preset on air, the rightmost button will be labeled
.
S P
AVE RESET
B) Press the S P
AVE
The Save Preset screen appears.
C) Choose a name for your preset.
Some non-alphanumeric characters (such as < and >) are reserved and
cannot be used in preset names.
D) Use the knob to set the each character in the preset name. Use the Next and
Prev buttons to control the cursor position.
E) Press the S C
AVE

You cannot give a user preset the same name as a factory preset. If the
name that you have selected duplicates the name of a factory preset, the
5500 will suggest an alternate name.

If the name you have selected duplicates the name of an existing user pre-
set, the 5500 warns you that you are about to overwrite that preset. An-
swer Y if you wish to overwrite the preset and N
ES
swer N , the 5500 will give you an opportunity to choose a new name for
O
the preset you are saving.
You can save user presets from the 5500 PC Remote application. (See Using the
5500 PC Remote Control Software on page 3-58.) Please note that when you save
presets from the PC Remote application, you save them in the 5500's memory (as
if you had saved them from the 5500's front panel). The PC Remote application
button.
RESET
button.
HANGES
ORBAN MODEL 5500
otherwise. If you an-
O