Analog Landline (Ptt/Post Office Line); Using The Orban 8100Ast (Or 8100A/St) External Agc With The 5500 - Orban OPTIMOD-FM 5500 Operation Manual

1-18
INTRODUCTION ORBAN MODEL 5500
they are configured for composite operation (even if a composite FM stereo signal is
not actually being applied to the link).
Nevertheless, in a dual-microwave system, the 5500 is usually located at the main FM
transmitter and is driven by the microwave receivers. One of Orban's studio level
control systems, such as the 8200ST, protects the microwave transmitters at the stu-
dio from overload. These units also perform the gain riding function ordinarily exe-
cuted by the AGC section of the 5500's processing and optimize the signal-to-noise
ratio obtainable from the dual-microwave link.
If the STL microwave uses pre-emphasis, its input pre-emphasis filter will probably
introduce overshoots that will increase peak modulation without any increases in
average modulation. If the studio level control system is capable of producing a pre-
emphasized output, we strongly recommend that the microwave STL's pre-emphasis
be defeated and pre-emphasis performed in the studio level control system. This
frees the system from potential overshoot. (The Orban 8200ST can be readily con-
figured to produce a pre-emphasized output.)
Further, it is common for a microwave STL to bounce because of a large infrasonic
peak in its frequency response caused by an under-damped automatic frequency
control (AFC) phase-locked loop. This bounce can increase the STL's peak carrier de-
viation by as much as 2dB, reducing average modulation. Many commercial STLs
have this problem.
Some consultants presently offer modifications to minimize or eliminate this prob-
lem. If your exciter or STL has this problem, you may contact Orban Customer Service
for the latest information on such services.

Analog Landline (PTT/Post Office Line)

Analog landline quality is extremely variable, ranging from excellent to poor.
Whether landlines should be used or not depends upon the quality of the lines lo-
cally available, and upon the availability of other alternatives. Due to line equalizer
characteristics and phase shifts, even the best landlines tend to veil audio quality
slightly. They will certainly be the weakest link in a FM broadcast chain.
Slight frequency response irregularities and non-constant group delay characteristics
will alter the peak-to-average ratio, and will thus reduce the effectiveness of any
peak limiting performed prior to their inputs.
Using the Orban 8100AST (or 8100A/ST) External AGC
with the 5500
If you have an OPTIMOD-FM 8100A1 (or 8100A or 8100A/1) installation that uses an
Orban 8100AST (or 8100A/ST) external AGC at the studio to protect an STL (with the
main 8100A, 8100A1 or 8100A/1 chassis at the transmitter), you may wish to con-
tinue to use the external AGC to protect the STL when you install the 5500 at the
transmitter.