Getting Started; Tools; Precautions - HP HPE 3PAR StoreServ 8000 Installation Manual

2 Getting Started

Before you begin, read the following guidelines to help you complete the installation successfully.
If you need assistance with the installation, contact Hewlett Packard Enterprise Support or see
the Hewlett Packard Enterprise Support website:
Hewlett Packard Enterprise Support Center (http://www.hpe.com/support/hpesc)

Tools

CAUTION:
a system hardware part.
The following tools are not required but can be useful, especially when unpacking or installing
the system:
ESD wrist-grounding strap
ESD mat
#1 and #2 Phillips screwdrivers
T25 Torx toolbit
1/8 inch (3 mm) slotted screwdriver
3/16 inch (5 mm) slotted screwdriver
Adjustable wrench
Diagonal cutting pliers

Precautions

To avoid injury, data loss, and damage, observe the following general precautions when installing
or servicing the system:
Using improper tools can result in damage to the system.
Prepare an ESD work surface by placing an antistatic mat on the floor or on a table near
the system. Attach the ground lead of the mat to an unpainted surface of the rack.
Always use the wrist-grounding strap provided with the system. Attach the grounding strap
clip directly to an unpainted surface of the rack.
Avoid contact between electronic components and clothing, which can carry an electrostatic
charge.
If applicable, ensure that all cables are properly labeled and easily identifiable before you
remove a component.
Observe local occupational safety requirements and guidelines for heavy equipment handling.
Do not attempt to move a fully loaded equipment rack. Remove equipment from the rack
before moving it.
Use at least two people to safely unload the rack from the pallet.
10 Getting Started
Always wear an electrostatic discharge (ESD) wrist-grounding strap when installing