Seat Belt Inspection - Mitsubishi Outlander 2007 Owner's Manual

Seat and seat belts
3. Push and pull the child restraint in all directions to be sure
it is secure.
WARNING
!
● For some types of child restraint, the locking clip (A)
should be used to help avoid personal injury during
a collision or sudden manoeuvre.
It must be fitted and used in accordance with the
child restraint manufacturer's instructions.
The locking clip must be removed when the child
2
restraint is removed.
2-52

Seat belt inspection

● Check the belts for cuts, worn or frayed webbing and for
cracked or deformed metallic parts. Replace the belt
assembly if defective.
● A dirty belt should be cleaned with neutral detergent in
warm water. After rinsing in water, let it dry in the shade.
Do not attempt to bleach or re-dye the belts because this
affects their characteristics.
WARNING
!
● We recommend you to have all seat belt assemblies
including retractors
inspected after any collision. We recommend that
seat belt assemblies in use during a collision be
replaced unless the collision was minor and the belts
show no damage and continue to operate properly.
● Do not attempt to repair or replace any part of the
sat belt assemblies; we recommend you to have this
work done by a MITSUBISHI MOTORS Author-
ised Service Point. Incorrect repair or replacement
result in serious injury in the event of a collision.
● Once the pre-tensioner has activated, it cannot be
re-used.
It must be replaced together with the retractor.
E00406300462
and attaching hardware