Mitsubishi Outlander 2007 Owner's Manual page 165

Instruments and controls
1- Odometer / Tripmeter
2- Odometer / Tripmeter
3- Service reminder
4- Engine coolant temperature display
5- Driving range display
6- Average speed display, average fuel consumption display,
momentary fuel consumption display
7- Function setting screen
8- Redisplay of a warning display screen
NOTE
● While driving, the function setting screen is not displayed
3
even if you operate the multi-information meter switch.
Always stop the vehicle in a safe place before operating.
Refer to "Changing the function settings (when the igni-
tion switch is "ON")" on page 3-27.
● When there is information to be announced, such as a sys-
tem fault, the buzzer sounds and the screen display is
switched.
Refer to "Interrupt display screen (when the ignition
switch is "ON")" on page 3-19.
Odometer / Tripmeter
The operation method is the same as when the
ignition switch is "OFF".
Refer to "Odometer / Tripmeter" for further
details on page 3-7.
3-14
Service reminder
This displays the distance and number of months
until the next periodic inspection.
Refer to "Service reminder" on page 3-14.
Engine coolant temperature display
This indicates the engine coolant temperature.
If the coolant becomes hot, the engine coolant
temperature display screen will automatically
appear and " " will blink.
Pay careful attention to the engine coolant tem-
perature display while you are driving.
E00521300015
CAUTION
!
● If the engine is overheating, the display
will be interrupted with a warning dis-
play. Then the engine coolant tempera-
ture display screen will appear and
" " will blink. In this case, the bar
graph is on the red zone. lmmeditely
park the vehicle in a safe place and
take the required measures. Refer to
"Engine overheating" on page 6-6.
E00521300028
E00521400016