Mitsubishi Outlander 2007 Owner's Manual page 418

1. Get the vehicles close enough so the jumper cables can
reach, but be sure the vehicles aren't touching each other.
CAUTION
!
● Check the other vehicle. It must have a 12-volt bat-
tery.
If the other system isn't 12-volt, shorting can dam-
age both vehicles.
2. Set the parking brake firmly on each vehicle. Put an auto-
matic transmission in the "P" (PARK) position or a man-
ual transmission in the "N" (Neutral) position. Turn off
the ignition switch.
WARNING
!
● Turn off the ignition on both vehicles beforehand.
Make sure that the cables or your clothes cannot be
caught by the fan or drive belt. Personal injury
could result.
3. Turn off all lamps, heater and other electrical loads.
4. Make sure battery electrolyte is at the proper level.
Refer to "Battery" on page 8-10.
WARNING
!
● If electrolyte fluid is not visible, or appears to be fro-
zen, Do Not Attempt Jump Starting!
A battery might rupture or explode if the tempera-
ture is below the freezing point or if it is not filled to
the proper level.
5. Lift up the front of the engine cover to release the 3 grom-
mets (A). Then, pull the engine cover towards you to
release the grommet (B) and remove the cover.
For emergencies
6
6-3