Mitsubishi Outlander 2007 Owner's Manual page 275

Starting and driving
Back sensor (vehicles with a towbar)
Vehicle to obstacle distance
Approx. 150 to 100 cm
Approx. 100 to 60 cm
Within approx. 60 cm
CAUTION
!
● The distances given are to be used for reference only,
as errors may be caused by various factors, such as
temperature, humidity, or the shape of the obstacles.
Changing the detection areas
4
The detection areas can be changed as follows:
Vehicles with a towbar
While the operation of the system is stopped at the "SONAR"
switch, push the "SONAR" switch approximately 3 seconds or
more, and release it. The buzzer sounds twice to indicate that
the detection area has been changed.
Vehicles without a towbar
While the operation of the system is stopped at the "SONAR"
switch, push the "SONAR" switch approximately 3 seconds or
more, and release it. The buzzer sounds once to indicate that
the detection area has been changed.
NOTE
● The detection area will not change if you keep the
"SONAR" switch pushed for 10 seconds or more.
4-52
Warning sound cycle
Intermittent
Fast intermittent
Continuous
E00615800045
Reversing sensor system operation indicator
lamp
In case there is a malfunction in the reversing sensor system,
the reversing sensor system operation indicator lamp will blink
and the warning buzzer will sound for approximately 5 sec-
onds. Even after the buzzer has stopped sounding, the indicator
lamp will continue blinking until the system reverts to the nor-
mal state. Have the vehicle inspected at a MITSUBISHI
MOTORS Authorised Service Point.
E00615900088