Hands-Free Bluetooth® Cellular Phone Interface System With Voice Recognition - Mitsubishi Outlander 2007 Owner's Manual

For pleasant driving
HANG-UP button
● Press this button when an incoming call is received to
refuse the call.
● Press this button during a call to end the current call.
When another call is on hold or there is an incoming call,
you will switch to that call.
NOTE
● When you press the SPEECH button to enter voice recog-
nition mode with a cellular phone paired to the system,
current information on the cellular phone, such as
"remaining battery life," "signal strength" or "roaming,"
will be displayed on the audio display.* (refer to "Pairing
a cellular phone" on page 5-86).
*: Some cellular phones will not send this information to
the Hands-free Bluetooth
tem with voice recognition.
● Call waiting and three-way calls can be used by the
Hands-free Bluetooth
5
with voice recognition, only when those services can be
used with your cellular phone.
5-80
®
cellular phone interface sys-
®
cellular phone interface system
Voice recognition function
®
The Hands-free Bluetooth
with voice recognition is equipped with a voice recognition
function. Your voice will be recognised by a microphone in the
room lamp (front), allowing you to make hands-free calls with
voice commands.
Voice recognition is possible for English, Spanish, French,
German and Italian. The factory setting is English.
Some of the voice commands indicated below have a number
of alternative commands. For a table showing the voice com-
mands in each language and the corresponding alternative
commands, refer to "Commands and Alternatives" on page
5-97.
NOTE
● If the voice command that you say differs from the prede-
fined command or cannot be recognised due to ambient
noise or some other reason, the Hands-free Bluetooth
cellular phone interface system with voice recognition
will ask you for the voice command again up to 3 times.
E00727300019
cellular phone interface system
®