RIDING INSTRUCTIONS
Riding through water
7.12
–
If you come to a stop on a slope with your vehicle, dismount from the vehicle and turn
it.
–
Switch off the engine and activate the parking brake.
–
Dismount from the vehicle on the uphill side.
–
Grasp the handlebar with both hands, release the parking brake, and carefully pull the
clutch.
–
Let the vehicle roll downhill carefully until you reach a location where you can turn it.
Control its speed using the clutch.
–
To turn the vehicle, steer it to the side. When doing so, you should always stand on the
400298-01
uphill side and apply pressure to the footrest on the uphill side.
–
When the vehicle is standing perpendicular to the slope or slightly downhill, apply the
parking brake.
–
Mount the vehicle, start the engine, pull the clutch lever and engage 1st gear. Cau-
tiously release the parking brake and ride down the hill in 1st gear.
–
Ride downhill. (
–
If you lose control over the vehicle, you should get away from the vehicle as fast as pos-
sible.
Warning
Danger of accidents The vehicle can roll over when riding through deep water
with a strong current.
–
Avoid riding through deep water with a strong current.
Warning
Danger of accidents Reduced braking efficiency due to wet or dirty brakes.
–
Clean or dry dirty or wet brakes by riding and braking gently.
400302-01
p. 37)
40