MAINTENANCE ON CHASSIS AND ENGINE
Removing wheel/wheels
9.51
Info
Proceed in the same way on the other wheels if necessary.
–
Remove the rear brake linings.
–
Remove screw
–
Press the brake piston back to its basic position and make sure that no brake fluid over-
flows from the brake fluid reservoir.
–
Install the rear brake linings.
–
Add brake fluid to level
Brake fluid DOT 4 / DOT 5.1 (
–
Mount screw
100070-10
Info
Clean up overflowed or spilt brake fluid immediately with water.
–
Pull handbrake lever, push the locking pawl
lever. (Figure 100006-10
x
(
p. 118)
with membrane
.
x
(
p. 119)
.
p. 190)
with membrane
.
p. 30)
downwards, and release the handbrake
122