Lancia Lybra Owner's Handbook Manual page 87

In this case, the search will follow
the station code order.
Press either button 17 or 18 briefly
to recall the stored stations in the re-
quired order. During selection, the
message "IS-SCAN" will appear on
the display.
Switching the IS operative mode off.
Press either button 17 or 18 for ap-
proximately three seconds until the
message "IS --" appears on the dis-
play.
The message "IS OFF" will then ap-
pear on the display.
In this condition, the search will be
made according to the order of pro-
gramme frequency.
The automatic station search is de-
scribed in detail in the specific para-
graph.
The sound system stores the last
search modality in memory ("IS ON"
or "IS OFF").
86
Pre-set station buttons
1, 2, 3, 4, 5, 6
Select the waveband (FM1, FM2,
FM3, MW or LW) by means of the
BAND 16 button.
Tuning to an RDS
station/programme
If the RDS station/programme
tuned to in the selected waveband
(e.g. "FM1") is stored at one of the
pre-set station buttons numbered
from 1 to 6, the respective digit will
appear on the display, e.g. "3" for
pre-set station 3.
Storing RDS stations/programmes
Press a pre-set station button num-
bered from 1 to 6 for longer than two
seconds until you hear the station
again.
The AF tuning function will be
stored with the station.
Recalling stored RDS
stations/programmes
Select the waveband (FM1, FM2,
FM3, MW or LW) by means of the
BAND 16 button.
Press a pre-set station button num-
bered from 1 to 6 briefly.
The stored stations will be kept in
memory even when the sound system
power is disconnected.
Tuning to RDS stations/
programmes with automatic
station search
1) Select the waveband (FM1, FM2,
FM3, MW or LW) by means of the
BAND 16 button.
For automatic searches in FM1,
FM2 or FM3 wavebands, switch the
IS operative mode off. In order to do
this, press either button 17 or 18 for
approximately three seconds until the
message "IS --" appears on the dis-
play. The message "IS OFF" will then
appear on the display.