Lancia Lybra Owner's Handbook Manual page 184

Table of Contents

Advertisement

20) Fit the cup on a regular size
wheel with the inflation valve N
(fig. 15) at the corresponding position
and press on the edge of the cup start-
ing from near the inflation valve. Pro-
ceed to complete fitting.
21) Place the removed wheel, the
jack and the tools in the boot and fas-
ten appropriately.
22) Reposition the shim (fig. 3).
fig. 15
Fasten the strap to the carpet as
shown (fig. 16) before refitting the
carpet on the floor.
IMPORTANT Do not fit the hub
cap or the wheel cap to the space-
saver wheel.
fig. 16
REFITTING THE STANDARD
WHEEL
1) Follow the procedure described
above. Raise the car and remove the
spare wheel.
2) Make sure the parts of the wheel
that comes into contact with the hub
are clean and that there is no grit
which could cause the wheel bolts to
work loose.
3) Fit the wheel by making the cen-
tring pins on the hub A (fig. 17) fit
into the holes in the rim.
fig. 17
183

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents