Lancia Lybra Owner's Handbook Manual page 25

SWITCHING THE ALARM OFF
To switch the alarm off, press re-
mote control button C (fig. 8). Then,
the system performs the following ac-
tions (with the exception of certain
markets):
– the direction indicators will flash
twice;
– two short siren sound signals
("BEEP");
– the system will unlock the doors.
IMPORTANT If LED in the car
stays on (for up to two minutes or un-
til the ignition key is turned to MAR)
when the alarm is switched off:
– If the LED stays on (fixed light) the
remote control batteries are flat. Re-
place them.
– If the LED flashes differently
from usual, an attempt has been
made to break into the car. The type
of break-in attempt is signalled by the
number of flashes:
24
1 flash: front right-hand door
2 flashes: front left-hand door
3 flashes: rear right-hand door
4 flashes: rear left-hand door
5 flashes: volumetric or anti-lifting
sensors
6 flashes: bonnet
7 flashes: boot/tailgate
8 flashes: tampered wires to start en-
gine
9 flashes: tampered battery wires
10 flashes: three or more causes of
alarm.
VOLUMETRIC PROTECTION
Do not leave passengers or pets in the
parked car and completely close the
windows and the sunroof (where fitted)
to ensure the correct operation of the
volumetric sensors. Furthermore, make
sure that the doors, bonnet and
boot/tailgate are properly closed.
ANTI-LIFTING SENSOR
The anti-lifting sensor detects vari-
ations in slant to signal lifting or par-
tial lifting (e.g. to remove a wheel) of
the car.
The sensor can detect minimal vari-
ations in car trim along both longitu-
dinal axis and transversal axis. varia-
tions in trim lower than 0.5°/min.
(such as, for example, a slow deflat-
ing tyre) are not taken into account.