Cruise Control - Lancia Lybra Owner's Handbook Manual

CRUISE CONTROL

GENERAL
The electronic cruise control allows
to drive your car at the required speed
without pressing the accelerator
pedal. This reduces fatigue when dri-
ving on motorways because the set
speed is automatically maintained.
IMPORTANT The device can only
be set to speeds exceeding 30 km/h.
fig. 118
122
(where fitted))
The cruise control must
only be used when the
traffic and road conditions
allow to keep a constant speed in
total safety for an adequately long
time.
The device is automatically switched
off when:
– the brake pedal is pressed
– the clutch pedal is pressed.
CONTROLS (fig. 118)
The cruise control is operated
by means of switch A, ring B and but-
ton C.
Switch A has two position:
– OFF: in this position, the device is
off;
– ON: this is the normal device op-
erating position. The CRUISE warn-
ing light D will come on when the de-
vice starts governing the engine.
Ring B is used to set and maintain
the car speed or decrease the set
speed.
Turn ring B to position (+) to set the
speed reached or to increase the
stored speed.
Turn ring B to position (–) to de-
crease the stored speed.
The speed will be increased or de-
creased by approximately 1 km/h
each time ring B is operated. Hold the
ring turned to set the speed continu-
ously. The new set speed will be au-
tomatically kept.
Button C allows to reset the stored
value.
IMPORTANT Turn the ignition key
to STOP or switch A to OFF to delete
the stored speed and switch the sys-
tem off.