The Electronic Alarm - Lancia Lybra Owner's Handbook Manual

Replace the batteries as follows:
– press button B (fig. 7) and bring
the metal insert A to the open posi-
tion;
– by means of a fine tip screwdriver,
turn the opening device G to : and
remove the battery holder H;
– replace the battery I observing the
proper bias;
– refit the battery holder into the key
and secure it, by turning the device G
to ;.
fig. 7
ELECTRONIC ALARM
The electronic alarm system fitted in
the car complies with EC directive
95/56 and consists of:
– a radio-frequency transmitter
(built into the ignition key);
– a radio-frequency receiver;
– an electronic control unit with
built-in siren;
– volumetric sensors which can be
deactivated (built-into the front ceil-
ing lamp);
– an anti-lifting sensor;
– a bonnet opening switch;
– boot/tailgate opening switch;
– door opening switches;
– warning LEDs.
The electronic alarm is controlled by
the receiver and is switched on by
pressing button D (fig. 8) and switched
off by pressing button C. Both buttons
are built-into the ignition key, which
sends the secret and variable code.
The electronic alarm - which addi-
tionally operates the central door
locking system - protects from the fol-
lowing actions:
(where fitted)
– illicit opening of doors, bonnet and
boot (perimetral surveillance);
– ignition switch operation;
– moving bodies in the passenger
compartment (volumetric surveil-
lance);
– attempts to lift the car;
– cutting of battery cables.
The volumetric surveillance function
can be deactivated, as required. Fol-
low the instructions given below.
fig. 8
21